Painting Straight Edges take skill ... or a good tape

Having trouble getting a clean straight line when completing your home painting projects? 


Reading this article posted by a fellow renovator. They use a product that 360renos uses when you want to have impeccably straight paint lines or when cutting in an Accent wall where two colors meet.

The first recommendation is to have a good brush. For interior work, I like an angled brush, as it allows getting into the corner easily, and a 1 1/2- to 2-inch brush works well. Some people like a chiseled brush, which is more like an artists brush, rounded at the tip.

Although patience is a great thing to have in painting, so is a good steady hand. If you lack one or both of those skills, you might want to consider using painters tape. The typical painters tape is blue, available in different widths. It's similar to a regular masking tape, but the blue tape doesn't stick permanently or take any of the surface off when it is removed.

In my early painting experiences, I tried cutting in with just a brush but wasn't satisfied with my results. I switched to using the painters tape. However, I became even more frustrated with this, because when pulling the tape off, I found that the paint often got behind the tape. This causes extra work in wiping it off and then touching up the area where I didn't want the paint to go. So, I went back to the brush only, forcing myself to learn the skill.

However, we have just run across a new painters tape that we've tried out and have found that it works well. It's called Frogtape (frogtape.com) and is available at Home Depot and Lowe's and other hardware stores. The tape is green, so you won't get it confused with the typical blue tape. The reason I like Frogtape is because it is treated with what they call a paint block. As paint is applied to the tape, a polymer on the tape absorbs the water in latex paints, expanding the edge of the tape and creating a barrier. Therefore the paint doesn't get under the tape. The manufacturer states that the tape was created for latex paints, so if you're using an oil-based paint, beware. The only drawback I've found in using this is that at times I had trouble making it stick, so it took more time to get it in place.

As with any painters tape, it is best not to leave it in place for too long after the job is done. If the paint has dried, you might be pulling up paint along with the tape. So, it is best to take the tape off before the paint is dry. Be careful removing it wet, however, not letting the tape touch any other surface, or you may be spending more time doing touchups.

Courtesy of Steve Cloninger

Happy Holidays

Dave Bennett
Owner
phone 613.429.5000 
mobile 613.282.2124
email dbennett@360renos.ca
www.360renos.ca

"Everything you can imagine is real" - Pablo Picasso

Mold in your Basement?

360renos was called in to review a finished basement which had a sub-floor that was sagging and warped due to a basement concrete slab that had heaved in some places and sunk on other places over time.


Well, the heaving was so bad that the 3 teleposts which support the main center beam of the home had either sunk into the earth or heaved up on their pads. It was a very dangerous situation as if this had not been rectified it would have eventually brought down the house.


The concrete slab needed to be demolished, so the sub-floor and interior walls were removed by 360renos. When this was completed we found a huge mold problem in one corner of the basement. This is an older home in Ottawa with cinder block foundation walls. The foundation and environmental experts have been called in!

So first to get this cleaned up with the experts before the next stage of pouring a new basement slab and re-building of the finished basement.


All of this reminded me of a great new article and tips by Bryan Baeumler and his series 'Room for Improvement'

Q: We have a major disaster in our basement due to a mold issue and now we are in a race to fix it. What is the best way to insulate the concrete block walls in the basement? Also, what are the best material to use for a basement subfloor? The current floor has foam insulation and plywood which seems to have worked extremely well but was 20 years old. Of course you could always drop by to take a look …. Cheryl and Mike

A: Hi Cheryl and Mike!

Sorry to hear about the mold in the basement – you’re definitely not alone! A lot of people have similar issues with finished basements that haven’t been waterproofed properly, have had a flood, or have high humidity levels in their homes. The silver lining in the cloud is that you now have the chance to finish the basement properly to avoid experiencing the same problem in the future.

It sounds like you’ve done the demo, which means you have a blank slate to work with. The first thing you ‘ll want to do is make sure you’ve taken care of the moisture problem. If it was a foundation leak, that means waterproofing the foundation wall properly, making sure your weeping tile system is operating effectively, ensuring proper grading of soil around your home, and directing water away from the house with downspouts. If you had a plumbing leak, obviously you’ll want to make sure the problem has been identified and corrected. And finally, if the mold was due to high humidity in the house, you’ll want to make sure you consult with an HVAC specialist to balance the system and install a dehumidifier to assist in lowering the humidity.

When it comes to insulating the foundation walls, you have a number of options. The best method by far is a closed cell spray foam – we use Walltite Eco, which you can ask about and have installed at your local Lowes. The reason spray foam works so well is that it has a high R value / inch, and eliminates any airflow – the biggest cause of heat loss. It can be sprayed right onto the foundation wall (block or concrete), and creates a monolithic insulation layer that won’t feed mold or lose R value due to moisture. You can also use the batt over spray method, which means spraying an inch of foam on the foundation wall, and adding either fiberglass or Roxul batts between the studs to increase R value, while still having the benefits of the air barrier from the foam. Roxul mineral wool insulation is another great product to use in a basement, as it’s fire proof and is a natural repellant to insects and rodents. If you plan on using batts, you’ll also need to vapour barrier the entire wall, tape the seams, and seal the top and bottom with an acoustic sealant. You’ll also want to be sure that you fully insulate and seal the joist bays (the area where your floor joists rest on the foundation) as the rim joist is one of the biggest culprits of heat loss. Not insulating and sealing the joist bays is a big reason people end up with cold floors above the basement, as cold air gets trapped in between the drywall ceiling and the floor above. If you go the spray foam route, joist bays and walls are all sprayed at once. We foamed our entire home, and we currently spend less than $50 / month heating it. We also filled all of the interior walls with Roxul to absorb sound and eliminate any wall cavities where fire could potentially spread.

When it comes to laying a subfloor, head for the Dricore – it has tongue and groove on all 4 sides to keep everything in place, it creates a thermal break from the floor that warms up the room, and also leaves an air space under the subfloor which allows for airflow so any moisture coming through the basement slab can evaporate. It also saves your finished flooring should you have a small amount of water under the floor, where it can flow to the drain. It’s also so easy and fast to install that it ends up being cheaper than other methods when you consider the cost of labour, or sanity. Foam laid directly on the subfloor will also keep your feet warm, but like a sheet of plastic it will eventually trap moisture – the idea is to give any water coming out of your slab somewhere to go and evaporate, something an impermeable layer laid directly on the concrete won’t do.

Of course there are lots of different products and methods to install a subfloor and insulate a basement (of which all done properly will perform well), so you have to make a decision based on your budget and skill level when it comes time to do the job. Most people would agree that the best method is never the cheapest, and the cheapest method is never the best. But when you look at the big picture, the best method is indeed often the cheapest in the long run.

Good luck, and have fun! (I’ll be over as soon as I can!)

Cheers,

Bryan

Fantastic info that can help a lot of home owners

360renos 
Dave Bennett
Owner
phone 613.429.5000 
mobile 613.282.2124
email dbennett@360renos.ca
www.360renos.ca

"Everything you can imagine is real" - Pablo Picasso

Bathrooms - Without the Eye Popping Price Tag

How to find the wow factor with out breaking the budget.

Updating the bathroom does not have to be an expensive under taking.

Some times a fresh coat of paint on the walls, baseboard and trim or just replacing light fixtures and towel racks will give the space a whole new look. Replacing the shower curtain can quickly change the look of the room, as can painting the cabinets in modern colors and replacing the pull knobs with decorative new handles. For a personal look add photos or art in simple frames. If the bathroom has a window replacing the shades are an economical way to enhance the bathroom. Look for honeycomb shades which reduce heat loss through your windows by up to 50%.

If you want to conserve water and reduce water heating costs you don't have to replace the bathtub or sink. Switch the shower head and faucets to ones with low flow aerators. Check out the impressive array  of designer styles in the latest low-flow toilets. There was a time when this range of products was limited and not very appealing. Now they are both effective and attractive.

360renos 
Dave Bennett
Owner
phone 613.429.5000 
mobile 613.282.2124
email dbennett@360renos.ca
www.360renos.ca

"Everything you can imagine is real" - Pablo Picasso

Paint is hot, waste is not

Have some leftover paint? Whether it's a little or a lot consider ....

• Recycling: Only a bit left? Decant it into a small glass jar to use for touch ups. Allow can residue to dry then put it out with your Blue box.
• Upcycling: Give that old dresser a fresh coat of paint. Voila: "New" furniture, no waste!
• Free cycling: Donate extra paint to Habitat for Humanity, ReStore or for sale to raise funds for community housing projects.
• Returning: Before you buy, check if your paint store takes leftovers back for safe disposal. Most Home Depot, Lowes and Rona stores do.

360renos 
Dave Bennett
Owner
phone 613.429.5000 
mobile 613.282.2124
email dbennett@360renos.ca
www.360renos.ca

"Everything you can imagine is real" - Pablo Picasso

Interior Painting - A Quick Fix to Your Home for the Holidays

With the holidays fast approaching, so are your holiday visitors. Is your home company-ready? If not, there's still time to do something about it, according to Debbie Zimmer, spokesperson for the Paint Quality Institute.

Why is it that we tend to spot deficiencies in our décor just before family and friends are due to arrive?

"In the throes of day-to-day living, most of us become somewhat blind to the condition of our rooms, including their color. But when it really counts, we take a harder, more critical look. All too often, we don't like what we see. When that happens, we are left with a couple of options: We can panic. . . or paint," says Zimmer.

Nothing changes the appearance of a home interior faster, or more effectively, than a fresh coat of interior paint, she says. And, giving a room an entirely new appearance at holiday-time can help lift your spirits and that of your guests.

What's especially nice about painting just prior to the holidays is that you can even choose colors that are appropriate for the season. . . as long as you'll still love them when the day is done.

Zimmer, an expert on color, offers some suggestions: "At Thanksgiving, fall colors that mirror the time of the year are most attractive -- harvest gold, ochre, brown, beige, and rust, for example. And nothing is cozier and more inviting at Christmas or New Year's than a special dinner set in a beautiful dining room decked out in a deep shade of red or green paint."

If you are really pressed for time, you can paint just an accent wall in a holiday-appropriate color, says Zimmer. "Painting even one wall can make a big difference in the appearance of a room and it can be done in a just a few hours. If you fall in love with the color, you have the option of painting the rest of the room at a later date, and if you happen to tire of it, you haven't invested much effort," she says.

Assuming that your pre-holiday painting is focused on rooms that will be filled with people, keep in mind that paints with higher sheen levels will be more stain-resistant and easier to clean. To make cleaning even easier, be sure to use durable top quality 100% acrylic latex interior paint.

And keep in mind that top quality latex paint offers another nice advantage: It has very low odor; plus, any minor odor it may have will dissipate very quickly. Even if you paint only a short time before your guests arrive, no one will catch a whiff of it!

So think about giving yourself and your family an unexpected gift this holiday season – the gift of color. The cost is very reasonable, and a beautifully painted room will provide pleasure not just at the holidays, but throughout the year!

For more information on color selection and interior painting for the Holiday season please contact 360renos

360renos
Dave Bennett
Owner
phone 613.429.5000
mobile 613.282.2124
email dbennett@360renos.ca
www.360renos.ca

"Everything you can imagine is real" - Pablo Picasso

Article with excerpts from Earth Times

Bathroom Wall Tile Updating

A main bathroom that was in need of a fresh new look from some tired old tiles.

We removed the old tiles and drywall down to the studs. Great news all was perfectly dry behind the old walls! Re-locating the plumbing to accommodate the new bath fixtures

Installed cement board for the new walls. Cement never goes mouldy so it is a great choice. Remember to use specialized screws for the installation of the cement board so they will not rust because you could have possible wall failure in the future.

New brushed nickel tile edging and 4"x4" tiles

Silicone caulking to complete all of the seams. New fixtures round out the updated style of this bathroom.

Dave - 360renos